In all probability, the manifold face is warped badly - a common problem on
these one-piece manifolds. Take it off again and have it surfaced at a
machine shop.
Lawrie
British Sportscar Center
-----Original Message-----
From: Phillip Farmer <pilot@ccc-cable.net>
To: MG <mgs@autox.team.net>
Date: Thursday, November 29, 2001 7:35 PM
Subject: exhaust leak
(SNIP)
>However - my problem. I had been running the car in carport while doing
>tune ups and the rebuild. No problems, but after I took the car for about
a
>5 mile run to check rear end work, it had blown out about 1/2 the gasket
>between the exhaust manifold and he catalytic converter. I had coated the
>gasket (from Moss) on both sides with copper spray. New studs and bolts
>when I put it back together.
>
>
>Any thoughts on possible cause and tips on doing it again?
///
/// mgs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
///
|