mgs
[Top] [All Lists]

Re: Cutting Question

To: "Ryan, Wesley" <wryan@giplastek.com>
Subject: Re: Cutting Question
From: Bud Krueger <budkrueger@earthlink.net>
Date: Fri, 16 Nov 2001 09:14:33 -0500
You'll find that Dremel has two different types of cutoff wheels.  One is 
thicker
and heavier duty than the other.  I have had good luck with the heavy duty ones,
they're much more forgiving.

Bud Krueger

"Ryan, Wesley" wrote:

> I am trying to cut a bolt off. I have tried the typical pb blaster and heat
> and to no avail I started to grind. However the grinder is to large to
> complete the cut (oh man what do I do know...I know write to the MG List).
> Anyhow I have a dremmel but have not had a ton of success because the blades
> seem to always break. anyone have any other ideas on how to cut a bolt off.
> is their better dremmel bits or small grinders available.????

///
///  mgs@autox.team.net mailing list
///  or try http://www.team.net/cgi-bin/majorcool
///


<Prev in Thread] Current Thread [Next in Thread>