In a message dated 9/27/2001 5:55:04 PM Eastern Daylight Time,
mmorris@nemr.net writes:
> Will fire, but not run, unless you keep the ignition switch to the
> start position then it will and seems to rev up fine (even though the
> starter is still engaged). It has been retrofited by PO probably at least 6
>
Does your ignition system still have a ballast resistor. If the resistor is
bad the car will start and then stop immediately after disengaging the
starter.
Jerry Rein
///
/// mgs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
///
|