Wes:
It appears he's still around.
http://www.huffakereng.com/history/history.htm
Wesley Pace wrote:
>
> What happened to old Joe Huffacker. Is he still around. Does he have any of
> his old MG stuff.
>
> Wes
>
> ----- Original Message -----
> From: Bullwinkle <yd3@nvc.net>
> To: Mick Anderson <mfanders@ozemail.com.au>
> Sent: Thursday, September 27, 2001 12:01 AM
> Subject: Re: Twin Cam - Re: Twin Cam conrods from engine 1343
>
> > Mick:
> >
> > On my engine, either a rod bolt came loose or broke. These rod's
> > bolts had special twelve point heads. The engine was dyno tested
> > by Huffacker (sp) a well known US MG engine builder. I don't
> > know if they built the engine or just tested it.
> >
> > In regards to the half speed shaft, I have two pieces minus a one
> > inch section just like yours.
///
/// mgs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
///
|