Thank you all for the info about the short that I'm experiencing. I've
ordered a new ignition switch and Crane electronic ignition. Are the
instructions for installing the Crane ignition fairly explicit (can a
non-mechanic understand them) or will I need the list's help? Do I
completely remove the old electronic ignition, which is attached to the
distributor on the block side? I read somewhere that I'll need to bypass
some resistor after installation, is this a slender "do-whicky" about three
inches long and half an inch wide that sits on the fenderwell with two
wires coming out of it?
Thanks, I hope this allows me to get back to DRIVING instead of REPAIRING!!
Monte,
79B
///
/// mgs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
///
|