I just installed an OD trans in my 78B. Before the conversion, the speedo
needle jumped and never gave an accurate reading. As this is a typical
sympton of a bad cable, I never did anything about it until I installed the
new trans, since, I needed to install a new, longer cable.
Now the speedo gives accurate readings at 45 mph or below (18miles/1000rpm in
fourth, and 22 miles/1000 rpm in 4th with the OD in) but at higher speeds the
speedo reads low. The faster I go, the greater the difference. Does anyone
know how to calibrate the speedo?
Maynard Hirsch
78B
67B
86XJ6
///
/// mgs@autox.team.net mailing list
/// (If they are dupes, this trailer may also catch them.)
|