>My source says:
>
>"The correct offset is ET 20 mm. The PCD is 4 lug on 114.3 pitch. The
thread type for the nuts is 1/2" UNF."
Max,
You musta saved the same message as I. The one I have is dated 4/99
from someone named Duncan Hadley.
What does ET mean? How about PCD?
RE offset: 20 mm = .787" Other sources I've seen indicate .5". Then
again I've heard there are different offsets for the early steel wheels
and two different offsets on Rostyles.
Any confirmation?
Larry Hoy
///
/// mgs@autox.team.net mailing list
/// (If they are dupes, this trailer may also catch them.)
|