mgs
[Top] [All Lists]

Re: Midget wheel bearings

To: <JERTIGGER2@cs.com>, MG List <mgs@autox.team.net>
Subject: Re: Midget wheel bearings
From: "Larry B. Macy" <macy@bbl.med.upenn.edu>
Date: Sat, 14 Jul 2001 08:52:14 -0400
Nope the standard are ball bearings. And there is a thrust side to them.
There is a pretty good diagram and discussion in the Moss catalog on which
way they go.

Larry

On 7/12/01 8:00 AM, "JERTIGGER2@cs.com" <JERTIGGER2@cs.com> wrote:

> I just found out the wheel bearings in my Midget are ball bearings, they were
> loose and I tried to tighten them, no go.
> I can get the bearing locally, are the standard bearings on the Midget
> tapered bearings rather than standard ball bearings? The spindle seems to be
> set up for them.
> 
> TIA 
> Jerry Rein 
> 73 Midget
> 

> 

-- 

Larry Macy
78 Midget

Keep your top down and your chin up.

Larry B. Macy, Ph.D.
macy@bblmail.psycha.upenn.edu
System Manager/Administrator
Neuropsychiatry Section
Department of Psychiatry
University of Pennsylvania
3400 Spruce St. - 10 Gates
Philadelphia, PA 19104

 Ask a question and you're a fool for three minutes; do not ask a question
and you're a fool for the rest of your life. 

///
///  mgs@autox.team.net mailing list
///  (If they are dupes, this trailer may also catch them.)


<Prev in Thread] Current Thread [Next in Thread>