something like this!
http://www.teglerizer.com/mgstuff/ob_od_switch/obie_od_switc
h_swap.htm
Paul Tegler ptegler@cablespeed.com
www.teglerizer.com
----- Original Message -----
From: "Ken Waringa" <kwaringa@dynsys.com>
To: "Max Heim" <mvheim@studiolimage.com>; "MG List"
<mgs@autox.team.net>
Sent: Thursday, June 07, 2001 7:12 AM
Subject: RE: Overdrive solenoid problem?
> Max Heim wrote:
>
> "One might be tempted to peel back the tunnel carpet and
cut an access hole
> right on top of the silly thing, should it turn out to be
the problem after
> all. You could always screw a cover plate back over the
hole; it would be
> hidden by the carpet."
>
> Max this exact procedure was recommended to me by a very
knowledgeable MG
> individual. He gave me the dimensions to drill a hole in
the tunnel prior
> to installing the engine and gearbox. After the gearbox
is in place, you
> will be able to see the exact location of the switch
through the hole. He
> recommended lowering the gearbox and cutting a hole so you
could get to the
> switch. Then cover the hole with a plate and a couple
screws. Just make
> sure to seal the plate so water won't seep into the
carpets. You now have
> access to the switch with everything in place.
>
> Ken
///
/// mgs@autox.team.net mailing list
/// (If they are dupes, this trailer may also catch them.)
|