everything is a straight bolt in.
At least it was on my pair of '73 BGT's
when I swapped motors and trannies.
The O/D wiring is part of the main harness.
Just check your wiper switch in the non-o/d car
to see if the switch is there. If not swap the column
switch as well.
...same rear cross mount just slightly different
positions of the mounts. (O/D tranny is a bit longer)
yep..and use the driveshaft from the O/D car.
Paul Tegler ptegler@gouldfo.com www.teglerizer.com
----- Original Message -----
From: "Phil Cleobury" <mgsoftt@yahoo.com>
To: "mg mailing list" <mgs@autox.team.net>
Sent: Monday, June 04, 2001 2:27 PM
Subject: Overdrive interchangability
Hi All
I have an additional question regarding
overdrives.....
I have a MGB roadster 1968 (without Overdrive) and am
parting out a MGB roadster 1971(with overdrive).
My question is.... can I take the overdrive unit (plus
wiring) and successfully bolt it straight into the
1968 car?
or do I need to modify anything and use the O/D drive
shaft?
Regards
Phil
Get personalized email addresses from Yahoo! Mail - only $35
a year! http://personal.mail.yahoo.com/
///
/// mgs@autox.team.net mailing list
/// (If they are dupes, this trailer may also catch them.)
|