Oops. Hit the send button before I was done. Sorry.
Gotta ask this again, as there were zero responses, and if I'me going to
order a new part, I'd like to get one on order. Here's the edited version:
I haven't been inside an engine since the early '70, so I dove in with a
little
hesitation. Not too bad once I got things going.
<big snip>
I found the vacuum tube between the carb and the dizzy was just a
loose slip fit at the joint below that thingy in the middle of the tube
assembly (What is that thingy, anyway? An accumulator?) Any suggestion
for reconnecting this joint for someone who does a lousy job with a
soldering gun? Super glue? JB Weld? Duct tape? <g>
Steve
Steve Morris Avon, Ohio
1958 MGA 1500 Red/Black
NAMGAR #5987 BuckAyes Ohio Chapter
LoCo Brits <mailto: MGA1500@mac.com>
http://www.en.com/users/smorris/mga/
///
/// mgs@autox.team.net mailing list
/// (If they are dupes, this trailer may also catch them.)
|