If you set the gap to .015, then measure the dwell, that will tell you. The
points gap is the same for both types. Personally because adjusting in situ
is such a pig (particularly on the RHD) I take it out and set it by gap, and
use dwell just as a check at following services.
PaulH.
----- Original Message -----
From: Neil Cotty <neilc@apphosting.com>
To: 'MG Mail list' <mgs@autox.team.net>
Sent: Thursday, March 15, 2001 12:31 PM
Subject: Distributors - 25D/45D
> Hi all,
>
> A friend of mine recently bought a 45D, remade into a 25D for his 64B.
This is
> in the UK. Can someone tell me if the shaft they use is from a 45 or a 25
as
> it affects the dwell. The dwell is 60 for the earlier models and 51 (ish
can't
> recall exactly) for the 45. Anyone know off hand?
///
/// mgs@autox.team.net mailing list
/// (If they are dupes, this trailer may also catch them.)
|