Better check your micrometer. My data says journals should be 1.8759" -
1.8764." You are above that, which means they are too big, not ground.
Carl Elliott wrote:
> I picked up a partly assembled engine. It has been bored the crank is
> installed with new bearings. Pistons came with new rings and several
> sets of bearings.
> I mike the crank at 1.885 What size bearings .010 under , .020 under
> There were boxes of .010, .020, and .030., My shop manual is in very
> poor shape and I can't read the specks. I know buy a new manual . I will
> order one tomorrow.
> Also what is the clearance .001 if I remember, and Torque on nuts 30-35
> ft. lbs
> All help appreciated. Carl E.
|