I think that "BB" might be part of the float assembly. You may want to
check into that...
On Mon, 06 Nov 2000 21:14:01 -0800, DuhCaddyhm wrote:
>Hi everyone!
>
>THANKS for all the help and suggestions on getting my Midget started.
>Most of it I'd already tried, but with a combination of things ..... I
>got it running and drove it around today for a while!!! First run in
>three months!
>
>The timing is out 180, but when I had switched wires before, nothing
>happened. This weekend I rebuilt both carbs ..... 1/4 inch of garbage
>in the float bowls and a general mess all over. Even found a small
>bearing (like a little BB) in one of the float bowls! Put the carbs
>back on this morning, adjusted them, and still wouldn't start. Tried
>switching the plug wires again .... and wah lah ... started right up!
>So, between that and the carbs, it's going! At least I did manage to
>get all the little stuff done that I'd been putting off. Next is the
>paint job!
>
>Again, thanks!
>
>Sue
>'74 Midget
>'65 Midget
>'65 MG-1100
>
--
Andrew Lundgren
lundgren@byu.net
http://www.itwest.net/~lundgren
|