SK makes one.
check http://pages.prodigy.net/larryhoy/MGTechSocket.htm
Larry HOy
>-----Original Message-----
>From: owner-mgs@autox.team.net [mailto:owner-mgs@autox.team.net]On
>Behalf Of Matthew Trebelhorn
>Sent: Monday, October 30, 2000 1:29 PM
>To: mgs@autox.team.net
>Subject: Tube Axle hub nut socket
>
>
>I need to replace my hubs to go with my new wheels; to do this I need a
>1 and 5/16 inch socket with a thin enough wall that it will fit inside the
>hub.
>
>Net-wisdom a few months ago said that Craftsman, Mac, Snap-on all had pieces
>that would work.
>
>Well, scratch Craftsman. They only make thru 1 and 1/4 in a 1/2" drive, and
>all their 3/4" drive sockets are thick wall. Apparently, the primary use (at
>least around here) for these big sockets is tractor lug nuts, and thin wall
>sockets were not lasting too long...
>
>So, it looks like it's down to Mac and Snap-on.
>
>Just FYI...
>
>Matt
>
>____________________________________________________________________
|