I double check the float height by letting out the choke, taking off
the piston, and letting the carb bowls fill wth fuel. Looking down into
the jet opening, you should see the fuel about 1/16" below the top of
the jet. If there is fuel running out of the jet, then the level is too
high, or you have a leaky needle valve.
Max Heim wrote:
>
> With these, you adjust the float height by using extra washers under the
> valve seat. Check to see if your float height is within spec.
>
> Dereck C had this to say:
>
> >Float level too high (I can't adjust the plastic
> >floats and they don't seem to leak)
>
> --
>
> Max Heim
> '66 MGB GHN3L76149
> If you're near Mountain View, CA,
> it's the red one with the silver bootlid.
|