Notice the novice, not the newbie...means this particular repair is a
first time for me.
Story: clutch on a 76B, 4 speed works fine before this situation...clutch
hydraulics disappear on a nice Sunday afternoon drive.
So I replace the MC, the SC & the line (not pretty but intact). Bleed the
line but then, I don't know what bleeding really means (and thanks for
some of the older answers a bit ago guys). Tried a few things but am stuck
now.
Symptoms: clutch point at the floor or below the floor
trying to get into reverse creates a horrible grinding noise 8 out
of 10 times (which makes me think the engagement point is beyond my foot's
reach),
with a bit too much effort I can go from 1st to 2nd to 3rd to ....
I certainly would appreciate some help about i) what to do next and ii)
explain to me what is the mechanical issue that I am stuck with.
TIA,
Bill
'76B
"Sacred cows make divine hamburgers."
|