Hi there,
I have a new crank and I have to install a new spigot bush. I don't
unfortunately have the old crank to see how that one was set up. My question
is how far do I drive the new bush into the crank? Do I drive it all the way
to the internal lip inside the crank (which would seem obvious <G>) or is it
supposed to be just flush with the inner chamfer of the hole (technical term
;) which leaves it some way from the lip.
Cheers,
Neil
--
61 A / 70 BGT / 68 CGT/ 56 BN2
URL: http://www.apphosting.com/mgstuff/
|