mgs
[Top] [All Lists]

Re: Flywheel Bolts and Locknuts

To: yd3@nvc.net
Subject: Re: Flywheel Bolts and Locknuts
From: Bob Howard <mgbob@juno.com>
Date: Fri, 18 Aug 2000 12:51:07 -0400
  There is one in the Harbor Freight catalogue.
Bob


On Thu, 17 Aug 2000 23:42:22 -0700 yd3@nvc.net writes:
> Cosmo:
> 
> RE: Lockwire pliers
> 
> <<<snip>>>
> OK, I'll bit. Do you know if a special tool is used to twist the 
> wire.
> <<<snip>>>
> 
> Yes, there is a tool for this and I've got one.  It's similar to a 
> pair of
> needle nose
> pliers, but is lockable like a pair of forceps.  In addition there 
> is a spiral
> shaft similar to that used on the old Stanley manual "Yankee Drill" 
> that you
> pull on which causes the pliers to spin.  I've seen them in 
> Eastwood's catalog
> (That's not where I got mine), and they may possibly be available 
> elsewhere for
> less.
>

<Prev in Thread] Current Thread [Next in Thread>