Mike,
Wire it in - carefully thread the wire through the core and onto the edges
of the sensor. Perhaps a bit of overkill, but a LOT of peace-of-mind!
Bill
----- Original Message -----
From: "Mike Razor" <mrazor@mis.net>
To: <mgs@autox.team.net>
Sent: Sunday, August 06, 2000 5:51 PM
Subject: Fan Sensor
> Put in new grommet, new sensor and got a white plug in from a buddy
> with an old MG parts car. The thing still wants to pop out! Could an
> overfilled expansion tank cause this? Someone suggested that I take
> one of the clips off the heater and use it to brace the sensor in. Not
> sure my untrained eye sees how it is done.
> Any suggestions?
> THANKS MUCH!
> Mike R
>
>
|