The 'correct' parts will be cut to the correct length for the application,
and brake pipes for a Rostyle axle are longer than for a wire-wheel axle.
PaulH.
----- Original Message -----
From: Max Heim <mvheim@studiolimage.com>
To: <mgs@autox.team.net>
Sent: Thursday, August 03, 2000 4:40 AM
Subject: Re: Rear brake lines
> Uh, doesn't Moss sell pre-cut-to-length kits? The brakes would be in the
> same locations on a C (obviously) -- unless the fittings are different?
>
> Tweedy, Todd had this to say:
>
> >
> >
> >
> >The rear end of the C is almost complete, and looking fantastic by the
way
> >She's re-sealed, repainted, new leaf springs, new (re-built) lever arm
> >shocks, new straps, new everything, and all that is left is to replace
the
> >break lines.
> >I appears the PO had replaced them before an used lines which where much
> >to long, thus lots of unneeded bends.
> >I would like to make it as clean as possible by using the shortest lines
I
> >can.
> >I picked up a 12' and a 40' yet they seem (with out bending them yet)
that
> >they will be to short.
> >
> >Suggestions????????????
> >
> >Thanks
> >Todd
> >69' MGC
> >
> >
> >
>
>
> --
>
> Max Heim
> '66 MGB GHN3L76149
> If you're near Mountain View, CA,
> it's the red one with the silver bootlid.
>
|