Mine did it once, the float was stuck. If you have the tin float, it could
also be filling with gas.
Joe
'75 Roadster lowered and loud
>===== Original Message From Jon <a77mgb@yahoo.com> =====
>I'm not sure my last message went out, so here it is again:
>
>Anyone running a DCOE? Mines dumping gas out the rear venturi when trying to
start the engine. It may have been doing this for a while, but I noticed it
when it wouldn't start after washing/degreasing the engine, replacing the
rotor/cap/plugs and
>installing a K&N filter (had to remove the DCOE's air horns to install the
K&N). I suspected I flooded it trying to start it after her bath. So I pulled
the cover off the K&N and fuel was pouring out. So, It let it finish, then let
it dry for a
>while and tried to start it. Gas started to pour while I was cranking it. I
pulled the cover, and it didn't look like a bad needle valve, because the bowl
only had about 1/2 inch of fuel in it.
>
>Any ideas?
>
>jon
>
>_______________________________________________________________________
>
>Free Unlimited Internet Access! Try it now!
>http://www.zdnet.com/downloads/altavista/index.html
>
>_______________________________________________________________________
|