In a message dated 7/1/00 12:30:54 AM Eastern Daylight Time,
spanlab@ceibo.entelnet.bo writes:
<< list, can someone please tell me how to adjust the break failure switch
so that the light no longer lights? Thanks,Enrique
>>
Unplug it from the electrical circuit!!!
But seriously, if it's on becasue you just bled the brake lines, go to a
bleeder screw on a pipe circuit OTHER THAN the last one you bled. Attach
your bleeder pipe. Have someone apply the brakes. Open the bleeder screw a
little bit. (Your assistant should feel the pedal move slightly as the
warniing switch shuttle valve begins to move to center). As soon as the
warning light goes out, shut the bleeder screw.
If you shut it too late, the shuttle valve will go past center and the light
will go on again. If this happens, you need to go to a bleeder on the other
pipe circuit.
|