Man, am I glad I don't live in the South. 90 degree weather with 95-98%
humidity is not fun.
Ok, here's an annoying problem and what I did with it. I'm looking for
other ideas to try.
98% of the time, the car starts fine. No problem...runs fine...lots of fun.
But that other 2%, the key goes into the ignition, nothing...nadda...zip.
No sound. No alternator light. No anything.
So I think battery and wiggle the cables on the battery.
Starts right up.
So I removed the ground wire, cleaned it, used my Dremel to clean the
chassis area where it
connects, replaced bolts to remove old, rusty, original ones (is this a
modification?), tightened everything down, and
of course it starts fine. Wed. the no-go happened again. (You
mathematicians might note the 2% failure rate is rising.)
So I did the same with the cable to the plus end of the battery, and really
tightened that sucker.
If I assume I took care of the problem, it'll happen this evening.
Where else might I recondition connections (the starter motor??) and, ugh,
should I think the ignition???
Gremlins like this I could do without.
Bill
'76B, newly insured with Hagerty! (a shameless plug because it saved me the
price of the junked engine I'm looking for)
|