Re: The story so far

[Charley & Peggy Robinson <ccrobins@ktc.com>]

Hi Geoff,

  I have a faint recollection of Kelvin telling me that it's a good idea
to put two washers under the banjo fitting on the outlet side.  This
prevents it from touching the pump housing when you tighten the bolt. 
Might take a look at that.

  I looked under lots of CBBs when I was preparing to replace a Midget
pump, that a PO had installed on my '69 B, with the correct pump.  Most
of them showed signs of fuel seepage at the fittings.

  FWIW,

  CR