Phil,
go to www.ntsource.com/~barneymg/mg01.htm
This is on Barney Gaylords site, and the tech. section has a good write up
on B series engine oiling systems and pumps.
Harlan.
---------- Original Message ----------------------------------
From: Phil Bates <jello@ida.net>
Reply-To: Phil Bates <jello@ida.net>
Date: Tue, 23 May 2000 21:03:00 -0600
>I am considering replacing he oil pump on my MGA. The car has a 3 main
>bearing 1800 MGB motor. It typically runs low on oil pressure, and
>since the bearings were replaced less than 10,000 miles back, I figure
>it must be the pump. So, here is the question - is there a high
>capacity or high pressure oil pump for these cars?? I see that APT
>parts lists pinto oil pumps, and I don't think they deal with a lot of
>pinto stuff. Anyone got suggestions here, or should I just get a new
>stock pump from one of the bigger suppliers (they are cheaper thatn APT
>on this one).
>
>Thanks!
>Phil Bates
>52 MG-TD replicar (VW)
>58 MGA
>66 Land Rover 88"
>66 Citroen DS21 Pallas
>67 MGB (with overdrive and wires)
>69 Porsche 911T targa
>75 Jaguar XJ12C
>86 Hond Accord Lx-i (for sale)
>
>
|