I am going to be going though an engine from a running parts car I drove for
about 45 days. The Engine is slimy with oil and dirt that built up over the
years. I am planning on going though the bottom of the engine and putting a
new head on it.
My question is how can I clean this up well enough to have a new coat of engine
pain look good on it?
I already have it out of the car. I cleaned it at the car wash while it was
still installed, but I didn't get a lot of the slime off. I have gone over it
with a scraper and pealed a bunch off but it is by no means ready. For the
most part you cannot see the original color of the engine still.
Thanks!
Andrew
|