| To: | "David Hill" <davhill@cwcom.net> |
|---|---|
| Subject: | Re: Barney's Eyebrows |
| From: | Barney Gaylord <barneymg@ntsource.com> |
| Date: | Mon, 06 Mar 2000 21:05:26 -0600 |
At 09:29 PM 3/6/2000 -0000, David Hill wrote:
>....
>If the block is eyebrowed, does the standard head gasket allow for this or
is a special required?
The standard head gasket clears the entire combustion chamber in the head,
so it will also clear the valves which are inside of the perimeter of the
chamber. See good pictures of the head gasket over the eybrows here:
http://www.ntsource.com/~barneymg/mgtech/engine/cm202d.htm
Barney Gaylord
1958 MGA with an attitude
http://www.ntsource.com/~barneymg
|
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: This is what happened to the N.A. MGC Register?, Elliott DeGraff |
|---|---|
| Next by Date: | Re: Eastwood pressure sandblasters, David F. Darby |
| Previous by Thread: | Barney's Eyebrows, David Hill |
| Next by Thread: | Re: Barney's Eyebrows, David Hill |
| Indexes: | [Date] [Thread] [Top] [All Lists] |