Major:
The white plastic part of the switch has tabs on the top and bottom that
have to be depressed before the switch will come out of the bezel. The
Bezel is held to the dash by a wire spring clip. I don't know if I can
describe the clip oveer the net very successfully. It is rectangular, holds
the bezel on the sides and springs against the dash above and below the
bezel. You may have to pull your radio console again and study the hazard
switch so that you can pull the others by feel. Good Luck
Richard in OK.
----- Original Message -----
From: Ruggiero Larry Maj AFRC/XPXS <Larry.Ruggiero@afrc.af.mil>
To: <mgs@autox.team.net>
Sent: Tuesday, February 01, 2000 10:07 AM
Subject: Switch Question
> Hi Listers... lurker and occasional lister Larry here with a quick
question
> about MGB rocker switches on '72 dashes: how do you get the dadblamed
things
> to release from the back of the dash?? When I redid my center console a
> couple years back I took out the flasher switch and freshened the bezel up
> with some "chrome" spray paint (looks nice, btw). I want to do the same to
> the dash switches that've long-lost their bezel chrome (lights, heater
fan,
> brake condition switch) but get frustrated everytime I try popping them
> out-- what's the trick? TIA...
>
> Larry Ruggiero
> Warner Robins GA
> '72 MGB
> '65 Midget mess
>
|