Tyson:
I've got a couple of pictures on my web site
http://www.shoyer.com/mgb/mgday.htm that show a couple of Weber downdrafts.
I don't know if you can see all of the lines, but it might help. On my car,
the vent tube from the side cover is routed down below the car. This is how
the Brit-Tek instructions said to do it, and it's how the car was when I got
it. I've seen some go into the bottom of the air filter on the carb, and I
don't know the reasoning behind just venting to the air, but it runs.
--Steve
-----Original Message-----
From: Tyson Sherman [mailto:mts3@ra.msstate.edu]
Sent: Tuesday, November 23, 1999 10:34 PM
To: MG Mailing List
Subject: 80 MGB Question - more info
...
Any thoughts on how the Weber is plumbed?
Thanks,
--
Tyson Sherman
76 MGB undergoing heart transplant / engine
blockectomy
mts3@ra.msstate.edu
ICQ# 10494960
http://www.tecinfo.com/~tsherman
|