Bob,
I have a 71 B too and what a pain getting those retaining clips out so you
can pull out the switch. Obviously you have to do it from behind as you
might expect. In any case is the switch still good? If not then what I did
was use a pliers, it works really well and you just break the heck out of the
switch ;) The new switchs have the plastic chrome around them already and it
is a different type of install, much easier. It got to be very frustrating
after spending a long time working on removing it.
Jeff
In a message dated 11/17/99 8:21:23 PM Eastern Standard Time, JstBob@aol.com
writes:
<< Subj: MGB light switch
Date: 11/17/99 8:21:23 PM Eastern Standard Time
From: JstBob@aol.com
Sender: owner-mgs@autox.team.net
Reply-to: JstBob@aol.com
To: mgs@autox.team.net
Help. I know I did this once years ago, but how do you remove the light
switch from a 71 MGB. This is the one with the wire retaining clip. (I
havn't
a clue what its retaining) The books tells of a tool 18G1145. Do I need
this?
It looks like I could make one if someone could tell me the measurements.
Bob, 71 mgb with hot wired lights
>>
|