O-rings are really easy to make.
To make/repair an o-ring all you need is a razor blade, some super
glue and some sandpaper. Measure to length. Cut the rubber
material at a 45 degree angle on both ends so they match up when
formed. Super glue the ends together. When dry, sand the joint to
make it smooth. Thats it.
They also come in a vast array of sizes if you don't want to make one.
Parker O-rings is a big supplier.
Check out www.parker.com/o-ring/Products/sizes.htm
Note, I'm just a end user and have no interest in the company.
-Dave
> Hardware stores often have a kit from which they make O rings to fit
>customer's needs. They have a selection of the rubber extrusion in
>various sizes. The rubber is put into a cutting jig, cut square at the
>ends, then measured a second time and glued end to end to make the
>o-ring. I have seen the kit for sale in the Harbor Freight catalogue
>also.
>Bob
>
>On Mon, 4 Oct 1999 19:48:32 -0400 "Mike Lishego" <mlishego@asheboro.com>
>writes:
> >Not to rain on your parade, but IIRC, those rubber gaskets that go
> >between the bezel and glass are made from 'unobtainium.' <I.e., not
> >available>
> >
> >You might could get some thin rubber gasket sheet from an autoparts
> >store and make your own...Or maybe one of the major companies has
> >started producing them again?
> >
> >
> >Michael S. Lishego
> >http://www.mgb.bc.ca/virtualgarage/
> >1991 Mazda Miata
> >1986 Plymouth Turismo T1
> >1974 MGB
|