Are you sure this is for a 1500 Midget??? You will likely have a problem
clearing the front tube of the header with the suspension. The flange
looks correct but the tubes do not.
Larry
At this exact moment in time 9/24/99 13:52, mgrazian@ltcm.com made the
profound statement:
>Hey folks. Someone asked me an interesting question. I have no idea what
>brand this header is. Neither did the seller (it was on a parts car). Can
>anyone venture a guess? THere's some heat discoloration on the tubes, but
>no rust anywhere but on a weld at the bottom (where the 4 tubes lead into
>one), and only a little.
>
>http://mgraziano.bizland.com/midgetheader.jpg
>
>Mike
>
> __/__,_
> _____(_o___o_)_______________________
> / \
>| Michael Graziano |
>| Long Term Capital Management L.P. |
>| Phone: 203-552-5706 |
>| Fax: 203-552-5869 |
>| Email: mgrazian@ltcm.com |
> \_____________________________________/
Larry B. Macy, Ph.D.
macy@bblmail.psycha.upenn.edu
System Administrator/Manager
Neuropsychiatry Section
Department of Psychiatry
University of Pennsylvania
3400 Spruce St. - 1015 Gates
Philadelphia, PA 19104
|
