At 10:09 PM 7/27/99 +0100, David Hill wrote:
>
>I got a Dremel tool ....
>I got some of the very thin cut-off wheels with the tool but they're
feeble things which snap as easily as a dry biscuit ....
I've had very good luck by putting two of the thin cut-off wheels on the
mandrel at the same time, very much stronger that way and they hardly ever
break. If you need a thin kerf, then use just one wwheel and take it very
easy with the cutting force. The edge of the wheel is so small that a
little force makes for a lot of pressure on the grinding edge. More force
doesn't cut any faster, just breaks the wheel.
Barney Gaylord
1958 MGA with an attitude
http://www.ntsource.com/~barneymg
|