Good try, but I didn't notice anything unusual when I replaced the a-arm
bushings. The pivot shaft looked nice and straight on both sides.
(haven't found the hidden gold bars yet)
Thanks,
Dennis Vaders
"There can be no great ingenuity
without
an admixture
of dementedness"... Seneca or somebody
-----Original Message-----
From: Ericsmgs@aol.com <Ericsmgs@aol.com>
To: vaders@WILKES.NET <vaders@WILKES.NET>; mgs@autox.team.net
<mgs@autox.team.net>
Date: Tuesday, July 20, 1999 11:13 PM
Subject: Re: Stump the experts: MG not level
>Dennis,
>Ahhhh, if only you could be so lucky as to find the Leprachans that left
the
>gold bars hidden in your car. If you are so lucky, send them my way!
>
>I ran across this same phenomenom a few years back on a car, and it turned
>out to be a bent lower A-arm pivot! This car had not been wrecked, but
>apparently had seen a rather large pot hole at some time. You might want
to
>check it out.
>
>Eric Swanger
>Huntersville, NC
|