Well, folks, I used a combination of suggestions and my own device.
For the clutch line and in the opening to the clutch m/c, a plastic tire
valve stem cap is the perfect fit.
For the brake lines, the little rubber end caps Bob describes (for covering
the tips of metal rods) worked well.
I still didn't figure out a way to stop up the openings in the Brake
M/C....sigh...fluid everywhere. Oh well.
Dan
73 B
>Dan,
> Try those white plastic/rubber caps that are sold to cover the sharp
>ends of metal closet shelving. They come in at least two sizes, and
>stretch. The small ones are handy to cover grease fittings.
>Bob
.
|