This is a multi-part message in MIME format.
--------------DC3CB3FB595D55A0331E111E
Heres how I do it... Remove the castelated nut.. but thred it out till
the top of the nut is even with the top of the stud. Get your biggest
ball-peen hammer... Whack the top of the stud with the hammer... It may
take a pretty hard whack to break it loos. Also do an inital alignment
with your tape measure before you drive it the front end shop for
alignment.
Tom McLaughlin wrote:
> Listers,
> This weekend I'm going to replace the steering rack boots on my 77B and
> it was suggested to me to replace the tie rod ends while doing the job.
> As usual, I hit a bunch of sites to read about how to do this. On
> Skye's web site he says, "used a J C Whitney lever balljoint separator
> to pop it apart." I don't have one of these. Where should I get one,
> from J C Whitney, Moss, local parts store?????? Or does it matter that
> much what source I get one from? It was also suggested that I need a
> BFH...I have plenty of these.
>
> Regards,
> Tom
> 77B
>
> BTW...Thanks Skye for the great site. It's the first one I hit when
> trying something new or looking for information...basically daily.
--------------DC3CB3FB595D55A0331E111E
name="djc.vcf"
Content-Description: Card for Dennis Cox
Content-Disposition: attachment;
filename="djc.vcf"
begin:vcard
n:Cox;Dennis
x-mozilla-html:FALSE
org:Applied Signal Technology
version:2.1
email;internet:djc@appsig.com
title:Systems Administrator
x-mozilla-cpt:;0
fn:Dennis Cox
end:vcard
--------------DC3CB3FB595D55A0331E111E--
|