No!! Stop, do not pass go, do not collect $200
If the master cylinder does not have the same fitting as the
original call the vendor immediately. Do not attempt to cluge(sp) and make
it fit!!!!!
It is possible the unit was; misboxed, mislabeled, incorrectly
pulled, incorrectly invoiced.
There should be a flat surface at the end of the cylinder suitable
for a copper washer to seal. The banjo seals to that surface. If there is
no flat surface suitable for a washer to seal, the product is incorrect.
Kelvin.
> -----Original Message-----
> From: Enrique Claure [mailto:spaninc@ceibo.entelnet.bo]
> Sent: Friday, April 23, 1999 10:39 AM
> To: mgs@autox.team.net
> Subject: Strange clutch MC
>
>
> Hi list, let me post this again. I got a Clutch MC from Moss and upon
> installation I noticed that the pipe was supposed to connect
> to the Banjo.
> Point is that my MC does not accomodate a Banjo. It has a
> pointy tip where
> a standard flare such as Break MC pipe connects. On the
> catalog diagrams, I
> notice the MC has a nut ending where the banjo sits flat on.
> Not this MC. I
> plan to connect the pipe directly to the MC no banjo. Anybody have
> experience with this type MC. Thanks Enrique
>
|