I had this same problem with my 77 B. Turns out it was my fuel pump not
putting out enough pressure to my Weber. Changed it and it's been fine ever
since. When I changed the fuel pump and got proper pressure, I developed or
exascerbated a problem w/my vacuum advance. I disconnected the vacuum line
and it runs fine although not as perky as it used to be. I'll replace the
vacuum advance unit soon.
FnS
<<Date: Wed, 21 Apr 1999 09:12:33 -0300
From: "Jones, Mark" <MJones@ngl.ca>
Subject: Won't start. Was: Dead Coil?
Your right. Now that I have read through the Haynes manual it is easier to
check the coil in the car as one of the steps in checking the ignition
system.
Maybe I should start from the beginning of the story:
Start the car Sunday afternoon as easily as normal. Drive a mile and it
dies, the engine just quits. I roll to a stop and try to start it. It
cranks over fine but no fire. I have fuel and I hear the pump running. I
let is sit for about 5 minutes and then try starting it again. The car
starts with a bit of extra cranking. I drive another 500 ft and it quits
again. I again try cranking it over with out luck. I walk home to get the
truck and tow rope and return within about an hour. I again try starting
the car and it does start but I need to give it full throttle to keep it
running. I turn the car off and tow it home and there it sits. It won't
start at all now. I have checked to see that the carb is receiving fuel and
it is, but maybe it is not enough volume, I don't know. My next step is to
follow the procedure in my Haynes manual to check the ignition system. Does
anyone have any other suggestions? Maybe an intermittent short?
Thanks in advance for your input.
Mark>>
|