Dan,
Check that bolt again; if it's like the two of them on my bench right
now, both of the bolts are relieved in the area of the hole so that the
fluid can flow around the bolt to the hole in the banjo fitting.
Bob
On Sun, 18 Apr 1999 16:05:24 -0500 "Dan Ray" <danray@bluegrass.net>
writes:
>I'm putting the banjo junction back onto my new clutch m/c and it's
>obvious
>that the hole in the bolt has to line up with the hole in the
>junction....
>But how the heck do I get the banjo to face the right direction now???
>When
>the bolt is tight, the junction faces the opposite direction from
>where the
>clutch line comes in.
>Should I just add another washer?
>TIA
>Dan
>73 B
>
>
>
|