| To: | "Dan Ray" <danray@bluegrass.net>, <mgs@autox.team.net> |
|---|---|
| Subject: | Re: 73B M/C Removal,- Reply |
| From: | "Scotty" <scotty@dove.net.au> |
| Date: | Sun, 4 Apr 1999 10:43:01 +0930 |
On Sunday, 4 April Dan Wrote
>>>>>>>>>.snip<<<<<<<<<
>Now everything is loose but the two nuts that fasten the housing to the
>firewall! Aarggh! Maybe these two nuts are the infamous Whitworth type
>(this is a pretty original car, mind you, which is good and bad for me),
>because 1/2" is too small, 9/16" is too big, and 13mm and 14mm don't fit
>either!
>>>>>>>>>end of snip<<<<<
Dan,
in this situation I use 'Metrinch' tools, sometimes they can't be
beat.
Have fun !!
Scotty,
Adelaide,Australia.
|
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: Bonnet Pad Set, Florrie & Allen Bachelder |
|---|---|
| Next by Date: | Re: another B master cylinder question, Nina Barton |
| Previous by Thread: | 73B M/C Removal, left/rear engine bay corner fixup, Dan Ray |
| Next by Thread: | Re: 73B M/C Removal,- Reply, Florrie & Allen Bachelder |
| Indexes: | [Date] [Thread] [Top] [All Lists] |