Mike,
I have in front of me the VB How to on interior renovation. It says:
>>>>>Quote:
REMOVE HEADREST ASSEMBLY FROM SEAT BACK
You may be able to accomplish this with a quick, forceful pull upwards
on the headrest, but only if the clip inside the shaft is well worn. If
this is not possible, then you must access the rear inside of the seat
back.
(...Dismantle the seat, pull the vinyl off... my digest of 8 short
steps)
Remove the seat foam and press in on the clp at the base of the headrest
shaft with a flat head screwdriver to remove the headrest.
<<<<<Unquote
Good luck with the quick, forceful pull upwards.
David Lynes, Woodstock, GA
73 Midget
78 MGB
Mike Cook wrote:
>
> I have 2 new headrests to replace the tattered ones in my 79 Midget. My
> question is (I hope) a simple one. How do I get the old ones out? There
> are no obvious set screws or some such, and they don't slide out easily. Do
> I just force them out, or is there a trick to this?
>
> Thanks
> Mike
>
> 79 MG Midget
> 97 Subaru Legacy Wagon
|