Hello All. I am rebuilting a 1800 5-main motor for a transplant into a 1600
A.
Ploit bushing is the forcoming problem. Has anyone made a ploit bushing to
fit into a 5-main crank. That will accept a small input shaft from a A-
tranny. I know I can install a large input shaft into the tranny. But anyone
who has disassemble a tranny. The input shaft is the last part to remove. In
short is there a adapter ploit bushing out there? Hope ya'll can understand
what I am talking about here.
Thanks John Flintstone, GA
PS. Does anyone have a 3-main 1800 rebuiltabe short block for sale or trade.
More costly backup plan.
|