Hello Skye,
It would be difficult to get an exact torque on the castelated nuts so
that you could still install the cotter pin, unless you were to employ
spacers.
Elizabeth Jones
Comfort, TX
At 02:24 PM 2/12/99 -0800, Skye Poier wrote:
>Hello, I'm in the final stage of rebuidling my front suspension and I know
>its important to do the final tightening once the car is on the ground
>but how tight should I torque up the two castle nuts at the rear of the
>spring pan and the castle nuts on the trunnion pins??? Not listed in
>Haynes..
>
>If anyone can answer this quickly, it would be much appreciated as I'm
>going to work on the car in 3 hours.
>
>Skye
>
>--
>1966 MGB The MGB Experience __,__\__ Safety Fast!
>GHN3L-70307 http://www.mgb.bc.ca/ (_o____o_) MGOFR 1.375
>
>
|