mgs
[Top] [All Lists]

Re: MGB engine mains

To: "Rick/Carolyn" <walters@mail.softcom.net>, <mgs@autox.team.net>
Subject: Re: MGB engine mains
From: "Lawrie Alexander" <Lawrie@britcars.com>
Date: Tue, 26 Jan 1999 22:10:50 -0800
Rick.............

No locating bushings. The caps will seat nica and square when torqued down.
Your proposed technique for starting the front and rear caps will work. Once
they are all the way down, be sure they are flush with the fore-and-aft
faces of the block where they seat. A tap with a hammer and a long punch
will enable you to get them flush before torquing them down.

Lawrie
British Sportscar Center
-----Original Message-----
From: Rick/Carolyn <walters@mail.softcom.net>
To: mgs@autox.team.net <mgs@autox.team.net>
Cc: Spridgets <spridgets@autox.team.net>
Date: Tuesday, January 26, 1999 4:00 PM
Subject: MGB engine mains


>Hi All,
>
>I have a question about installing the Main bearing caps.  Is there a
>locating bushing on them.  I just got my engine back from the machine
>shop and if there is locating bushings, they are gone.  Is there a trick
>to installing the end bearing caps, or do you just start them on an
>angle and drive them in gently with a rubber mallet.
>
>TIA
>
>Rick
>--
>52 MGTD,Sparky    74 MGB, B-tris    76 XJ12 Coupe, Jacque
>60 Bugeye, Puddles      58 MGA Coupe, Ruby
>http://www.softcom.net/users/walters
>http://www.geocities.com/Heartland/Acres/4644
>


<Prev in Thread] Current Thread [Next in Thread>