> I've seen reference to a helpful hint on how to make tool
> for removing
> the differential drain and fill pugs on the B. Does anyone
> recall where that's
> located. I think it starts out with a 5/8 in. bolt. Thanks.
It starts out with a 5/8" bolt, which you grind to a tapered square section
to suit the square socket in the fill plug. You could use plasticene, silly
putty or blu-tak to take an impression of the socket to be sure you don't
grind too much off the bolt. I made one, didn't take too long. KJeeping
hold of the bolt whilst grinding it was tedious, and it is useful to
remember that the bolt will get hot...
Andy
|