Andrew,
You will need to remove the heater motor to reach the bearing at the
fan end, but it is not essential to dismantle the motor to oil the other
bearing. Just drill a hole in the steel housing so that you can get oil
through the drilled hole onto the bearing.
Bob
On Wed, 06 Jan 1999 09:56:05 -0700 (MST) "Andrew B. Lundgren"
<lundgren@iname.com> writes:
>My heater motor is sounding really bad. I would like to lube the
>thing
>but I don't really want to to pull the entire thing apart to lube it.
>Is there someway to lube the motor without pulling the blower casing
>apart?
>
>Thanks!
>
>Andrew Lundgren
>Lundgren@iname.com
>http://www.itwest.net/~lundgren
>
>
|