Gee, you made me go out and check!!
In the front, sling it under the head (thermostat housing) bulge or the
water pump.
In the rear, thread it between the block and the rear plate, below the upper
two bolts.
Bill
-----Original Message-----
From: Gaetke <gaetke@ix.netcom.com>
To: Penny & Bill Meyer <pplusb@northlink.com>
Date: Saturday, January 02, 1999 2:11 PM
Subject: Re: more on the Thanksgiving debacle
>At 11:40 AM 1/2/1999 -0700, you wrote:
>>Don't know about the majority's choice, but what I use is 3/4" rope run
>>convenitently under projections ay the front and rear of the engine. When
>>balancing or tilting for removal/replacement, the rope slides nicely
through
>>the hook on the engine hoist.
>>
>>Bill
>>
>
> What projections do you use? I'm pretty leary of bending something using
>the valve cover stud method, and your's sounds better.
>
> -Matt
|