Assembling my carbs

["Neil Cotty" <neilc@tradesrv.com.au>]

Hi all,

A quick question. I have replaced the one piece exhaust and inlet manifold
gasket to block - dry - and are replacing the six carb/heat shield gaskets.
I have been giving varying advice to use and not to use gasket sealant. What
is the general consensus on this? Mine didn't have any form of sealant on
them when I removed them. I'm not sure if these are the original gaskets but
they look it to me.

Cheers,
Neil.
--
Neil Cotty - Sydney, Australia
1970 MG B GT / 1959 MG A 1600 Mk1