I'm a tad confused with all the cables but...John Twist talks
about using an OD cable to replace a non OD cable. You don't need the
90 degree angle when you switch to the OD cable but be sure to keep a loop
in the end.
...Art
On Fri, 20 Nov 1998, Gary Davis wrote:
> I've been off the list for about a month while they were upgrading our
>communications system and then ridding it of numerous bugs.
>
> I exchanged my OD speedo from my non-OD GT for a non-OD speedo from a lister
>a couple of months ago. The previous speedo had no angle drive on the speedo
>unit and worked fine except for erroneous readings. The cable made no noise.
>When I installed the "new" speedo, I broke the old speedo cable. I replaced
>the cable and the speedo works fine, but the new cable squawks like crazy. I
>called Moss and they said I needed an angle drive on the speedo, but
>apparently they are very difficult to find. I'm confused. The previous
>speedo cable didn't make any noise and everything is set up like before.
>
> I'd like to get this resolved ASAP so that I can drive again before winter
>really sets in.
>
> Thanks - Gary Davis
>
>
|